Description
Chain can come off the rear sprocket and cause damage to your dirt bike or ruin a race. This is not very rare case and can be caused by logs, rocks or ruts that bend the chain guide and in some other cases. Sprocket chain slider will not let the chain go too loose if it comes off and does not allow the chain go into bundle. It helps to prevent hits to engine casing by loose chain and also saves the sprocket nuts. As the sprocket chain slider supports the chain you can easily put it back to the sprocket and continue the ride.
Fits to KTM and Husqvarna enduro motorcycles since 2018 and up or similar.
Fits to Beta motorcycles.
Fits to GASGAS motorcycles by KTM.
Desinged for 18” wheel.
- Weight: 180 g
- Material: thermoplastic polyurethane
Installation
Remove rear wheel sprocket. Press (and slightly stretch if needed) the sprocket chain slider over wheel hub so that hub grooves are aligned with bolt holes. Put the sprocket back. Sprocket chain slider holds the wrench in place with nut for easier install. Use thread lock compound. Install and tighten the bolts in a criss-cross pattern. If needed refer to your user manual for sprocket installation. No need to remove the slider on sprocket change.
